ROQ.US Tech Tip: How to Maintain the ROQ PEEL Scraper for Smooth, Consistent Transfer Peeling

https://www.youtube.com/shorts/nVHLCsd5oyA

Routine maintenance is the key to keeping your ROQ Peel operating at peak performance. One of the most important—and often overlooked—maintenance tasks is cleaning and lubricating the scraper guide pins.

When these components become dirty or dry, the scraper may not close evenly, leading to inconsistent peeling, transfer issues, and unnecessary downtime. Fortunately, this maintenance takes just a few minutes and can help keep your production running smoothly.

Why Scraper Maintenance Matters

The scraper is responsible for grabbing your transfer sheet and peeling it away at the correct moment during production.

The scraper assembly consists of:

• A center cylinder

• Two guide pins—one on the left and one on the right

  
  

These guide pins allow the scraper to move freely and close evenly. If dirt, adhesive residue, or lack of lubrication causes them to bind, the scraper may not operate smoothly.

This can lead to:

• Inconsistent or incomplete peels

• Misaligned transfer removal

• Increased wear on components

• Reduced production efficiency

  
  

Regular cleaning and lubrication help prevent these issues before they impact your workflow.

What You'll Need

Before getting started, gather the following:

• A clean, dry cloth

• ROQ-approved grease

Tip: A small amount of grease goes a long way. Applying too much can attract dust and debris over time.

Step 1: Inspect the Scraper Assembly

Locate the scraper mechanism on your ROQ Peel.

Identify:

• The center cylinder

• The left guide pin

• The right guide pin

Check each guide pin for dirt, dust, adhesive buildup, or signs of sticking.

Step 2: Clean the Guide Pins

Using a clean, dry cloth, wipe each guide pin thoroughly.

Remove:

• Dust

• Dirt

• Adhesive residue

• Old grease buildup

A clean surface allows the scraper to move freely and evenly during operation.

Step 3: Apply Fresh Grease

Once the guide pins are clean, apply a small amount of ROQ-approved grease to each pin.

Remember:

• A light coating is all that's needed.

• Avoid over-greasing the pins.

• Apply the grease evenly for smooth movement.

Repeat the process on both the left and right guide pins.

Step 4: Verify Smooth Operation

After lubricating both guide pins, manually cycle or observe the scraper to ensure it moves freely and closes evenly.

If both guide pins move smoothly, your scraper is ready for production.

Benefits of Regular Maintenance

Taking just a few minutes to clean and lubricate the scraper guide pins can help you:

• Improve peel consistency

• Prevent mis-peels

• Reduce unexpected downtime

• Extend component life

• Maintain consistent production quality

• Keep your ROQ Peel running at peak performance

Make Preventive Maintenance Part of Your Routine

Small maintenance tasks like cleaning and lubricating the scraper assembly can prevent larger production issues down the road. By adding this simple procedure to your regular maintenance schedule, you'll improve reliability, reduce wear, and keep your transfer operation running efficiently.