ROQ.US Tech Tip: How to Lubricate the ROQ PEEL Slide Carriage

Keeping the peel slide carriage properly lubricated is a straightforward maintenance task that helps the carriage move smoothly. This guide walks through the process of locating the grease fitting, applying grease, and cleaning up afterward.

Safety first: Before beginning, engage the machine’s safety bar and follow all applicable equipment safety procedures. Consult the manufacturer’s maintenance instructions if your equipment differs from the configuration described here.

https://youtube.com/shorts/n2jT4vCuk5E?si=yeHKRktBK3YwW9pJ

What You’ll Need

Item	Purpose
Grease gun	Applies grease to the fitting.
Clean shop towel or rag	Removes excess grease after lubrication.
Appropriate personal protective equipment	Supports safe maintenance work in accordance with site procedures.

Step-by-Step Instructions

1. Secure the equipment

Begin by placing the safety bar in the engaged position. Confirm that the equipment is secure before reaching into the peel carriage area.

2. Move the peel carriage back

Grasp the peel carriage and move it fully to the rear. This creates access to the grease fitting located in the carriage channel.

3. Locate the zerk fitting

Look in the center of the channel where the peel carriage sits. The zerk fitting is positioned there, although it may be difficult to see depending on the viewing angle and equipment configuration.

4. Attach the grease gun

Hold the carriage steady with one hand. With the other hand, seat the grease-gun nozzle securely onto the zerk fitting. A firm connection helps prevent the nozzle from slipping while grease is applied.

5. Apply grease

Pump the grease gun three to five times. Use only the amount needed for this routine lubrication step; avoid over-applying grease.

6. Remove the nozzle and clean the area

Pull the grease-gun nozzle straight off the fitting. Then use a clean shop towel to wipe away any excess grease around the zerk fitting and carriage channel.

Maintenance Checklist

Checkpoint	Complete
Safety bar engaged before servicing	✅
Peel carriage moved fully back for access	✅
Zerk fitting located in the center of the channel	✅
Grease-gun nozzle attached securely	✅
Grease applied with 3–5 pumps	✅
Excess grease wiped away	✅

Wrap-Up

Lubricating the peel slide carriage takes only a few minutes: secure the equipment, move the carriage back, grease the center zerk fitting three to five times, and wipe away the excess. Adding this simple task to a regular maintenance routine can help keep the carriage area clean and operating smoothly.